Well, the work today was fast. Let me show you!
I started the build with the water tank (used only on the 251/8 ambulance version) and the panel board as is in steps one and two of the instructions.
Then I continued with the interior, the seats, the floor and the gear lever along with the brake.
The shafts and the hull fix with no problem. So, these parts was ready.
The wheels parts (right) and complete (left)
The front axle is very easy to build along with the sprockets and the road wheels
Before fix them, I primed the panel and the interior with Tamiya XF-1 Flat Black in my airbrush
After that the base color was Tamiya XF-60 Dark Yellow. I also took the opportunity to paint wheels. I try to make shadows effect in some areas.
I paint with brush the seats with Tamiya XF-64 in 75% and XF-1 Flat Black in 25%. The meters were paint with Flat Black and a soft movement with drybrush with XF-2 Flat White. The steering wheel was paint with Flat Black also the pedals and the tip of the gear lever.
I put Tamiya XF-66 Light Grey in a Q-tip and paint the floor for a worn out effect. After that I pass a drybrush with Tamiya X-11 Silver Chrome in the center of the floor.
I protect the pieces with a coat of Future wax. When were dry I made a mix with black and raw umber oil paints 50-50 and thinner them with white spirit for make a wash. I applicated it with a brush and clean the excess with a paper towel. I like the result.
I put a drop of Future on the meters like glass.
I like the wash finish. Is very contrasting with the colors and the floor. What do you think?
The interior was paint with Dark Yellow and washed with the same mix of oil paints.
I put the upper hull for the camera
The rear hatch with its pieces. Is very tricky put them on the hull by the way.
The fences are complete with the tools, muffler and boxes.
The pieces are ready for the primer and the paint work.
So far the work today. The next step will be exciting with the airbrush into action.
See you. Greetings from México
José
