here i have a review of the Marder III ausf. M initial by dragon
i thought i could do a review on it as this will be a upcoming build for me
so let's get started
the pretty cool box art
all parts that are on the goodie card
a close up of the decals
they look good not 100% flat but darn close
the photo etch looks good aswell with a nice amount of detail
the hull
a sprue of gen2 infantry gear
this is mostly for the spares box as the only things you need are the gasmask cases
radio parts
antenna's
the spare ammo
tools
interior parts
close up of some transmission parts
looks good
various exterior parts from the 38t but this has the same chassis so you would need some parts from it
the armor plates
the details of the armor
parts for the gun
as with the ammo sprue this comes from the pak40 kit dragon makes
and some more exterior parts
the wheels
i like that you get 2 sets of sprockets and 2 sets of idler wheels
this gives some extra detail choises
and even more exterior parts
this leaves you with more spares bin goodies
just wanted to show this one
these are the ammo storage tubes
and the floor for the fighting compartment
now follows the instruction book
please excuse all the writing in there
i already made some notes in there
the sprue map and as you can see a sea of unused parts
color charts
standard brands that dragon points out
and as a last page the painting and markings guide
and that concludes the review
i think this is a good kit with a lot of details
there is the normal busy instruction book but as with all kits take your time and you should be fine
i did found 1 bad thing , this bit
this is beyond bend i think
but this kit is really a great addition to the stash and if you see it at a good price just go for it
cheers Mark
